top of page

Which Confined Space Course Do I Need? Low, Medium or High Risk Explained

Nov 12
7 min read

Choosing the wrong confined space course can leave a worker underprepared for the actual job, or send them on training that does not match the entry method at all. The right choice starts with the work, not the course title.


For UK employers, safety managers and workers, the key question is simple: what does the task-specific risk assessment say? A confined space entry for visual inspection is very different from an entry involving deep chambers, restricted access, toxic atmospheres or breathing apparatus.


This guide explains how low, medium and high-risk confined space training differ, what hazards usually sit behind each level, and when roles such as top person, supervisor and rescue team may be needed. It also covers escape breathing apparatus, working breathing apparatus and practical points to check before booking training.


Wide-angle view of a confined space training area with workers preparing entry equipment
Training should reflect the real entry conditions workers will face.

Start with the risk assessment and method of work


A confined space course should match the entry task. That means looking at the specific space, hazards, access arrangements, work activity, rescue plan and emergency procedures.


The level is not decided by the job title of the person entering. It is not decided by whether the space “looks simple” from the outside. It comes from the risk assessment and safe system of work.


A task-specific assessment should consider:


  • The type of space, such as a tank, vessel, silo, sewer, chamber, duct, pit or culvert

  • The access and egress route

  • The atmosphere inside the space

  • The possibility of low oxygen, toxic gas, vapour, fumes or dust

  • The chance of flooding, engulfment or sudden release of material

  • Heat, noise, poor lighting, slips, trips and biological hazards

  • The work being completed, including cleaning, welding, cutting, inspection or maintenance

  • Communication between the entrant and people outside

  • Rescue arrangements that can be put in place without relying on emergency services as the only plan


Training supports safe work, but it does not make someone competent on its own. Competence also depends on experience, supervision, health and fitness, site knowledge, equipment familiarity and the employer’s safe system of work.


How low, medium and high-risk confined space training differ


The terms low, medium and high risk are commonly used to help select training. They describe the likely complexity of the entry, the hazards present and the emergency arrangements needed.


The table below gives a practical comparison. It is a guide, not a substitute for your own assessment.


Training level

Typical entry conditions

Common hazards

Typical training focus

Low risk

Simple access, good natural or mechanical ventilation, low likelihood of a hazardous atmosphere, straightforward escape

Slips, trips, poor lighting, restricted movement, minor atmospheric concerns

Hazard awareness, safe entry procedures, permits, basic monitoring, communication, emergency actions

Medium risk

More restricted access, possible specified risks, need for planned entry control, possible use of escape breathing apparatus

Oxygen deficiency, gas build-up, difficult access, poor communication, need for retrieval systems

Practical entry, gas monitoring, harness and tripod use, top person duties, emergency escape procedures

High risk

Complex or hazardous entry, higher chance of dangerous atmosphere or conditions, working breathing apparatus may be required

Toxic or irrespirable atmosphere, serious access restrictions, high rescue complexity, engulfment or process hazards

Working breathing apparatus, detailed entry control, team roles, rescue planning, casualty recovery, supervision


Low-risk work still needs planning. A shallow chamber with open access may sound simple, but changing conditions can raise the risk. An entry can also move from low to medium or high if the work activity creates fumes, disturbs sludge, uses chemicals or changes ventilation.


Medium-risk work often involves more control measures and more people. It may include a top person controlling the entry, maintaining communication and starting the emergency procedure if needed.


High-risk work needs a much more detailed system. People entering may need working breathing apparatus, and a trained rescue arrangement must be ready before entry begins.


Typical hazards that affect the course level


Confined space hazards are not always visible. Clear air is not always safe air, and a space that was safe yesterday may not be safe today.


The main hazard groups include the following.


Atmospheric hazards


Low oxygen, toxic gases, flammable vapours and airborne contaminants can make a space dangerous very quickly. Gas monitoring is often a core part of training because workers need to understand when and how monitoring is used, and what the alarm response should be.


Restricted access and exit


A narrow manhole, ladder entry or long crawl route makes escape harder. It also affects rescue. If a casualty cannot leave unaided, the team needs a realistic retrieval or rescue plan.


Engulfment and flooding


Loose materials, liquids, sewage, slurry and stored product can trap or bury a person. Sudden inflow can also change the situation within seconds.


Work-created hazards


The space itself may not be the only problem. Cleaning, hot works, resin use, pressure washing, cutting and chemical treatment can introduce new hazards.


Environmental and physical hazards


Heat, cold, poor lighting, sharp edges, noise, uneven floors and biological contamination can all affect the risk level. PPE may protect the worker, but it can also make movement and communication harder.


A good course should help learners connect these hazards to the controls used on site. That is why practical training matters. Workers need to practise with equipment, entry procedures and communication methods, not just talk through them in a classroom.


Close-up view of a gas monitor and harness beside a chamber entry
Gas monitoring and access equipment are central to many confined space entries.

Escape breathing apparatus and working breathing apparatus are not the same


Breathing apparatus is one of the most common areas of confusion when selecting training.


Escape breathing apparatus is used to get out of a space in an emergency. It is not for carrying on with the job. A worker may carry it during an entry where conditions are normally controlled, but where there is a foreseeable need to escape if the atmosphere changes or an alarm sounds.


For example, a medium-risk entry may involve escape breathing apparatus where there is a risk of atmospheric deterioration, but the normal method of work does not require the person to breathe from the set while working.


Working breathing apparatus is used when the person needs supplied air to carry out the task. This is associated with higher-risk entries because the atmosphere may be immediately dangerous, unknown or not suitable for normal breathing.


Working breathing apparatus changes the training need. Learners need to understand pre-use checks, wearing and operating the set, communication, movement in restricted spaces, duration limits and emergency procedures. The support team also needs to understand its role, because the entrant’s safety depends on the system around them.


Do not choose a course based only on whether a site has breathing apparatus in the store. Look at how the equipment will be used in the method of work. Escape use and working use are different, and the course must reflect that difference.


Extra roles may need extra training


A confined space entry rarely involves only the person going inside. The bigger the risk, the more important the supporting roles become.


The top person


The top person stays outside the confined space and controls the entry point. This role may include:


  • Keeping a record of who is inside

  • Maintaining communication with entrants

  • Monitoring conditions and equipment

  • Preventing unauthorised entry

  • Raising the alarm if something changes

  • Starting the agreed emergency procedure


The top person should not leave the entry point to attempt an unplanned rescue. Their value is in control, communication and early response.


The supervisor


The supervisor makes sure the planned system is followed. This can include checking the permit, confirming equipment is available, making sure people understand their duties and stopping work if conditions change.


A supervisor does not need to be the most senior person on site, but they do need enough knowledge and authority to manage the work properly.


The rescue team


For higher-risk work, a rescue team may need to be appointed, equipped and trained before entry starts. Relying on the fire and rescue service as the only rescue plan is not suitable in many confined space scenarios, because the first few minutes can be critical.


Rescue arrangements should match the entry. A vertical lift from a chamber needs one type of plan. A long horizontal crawl, tank entry or BA rescue needs another.


A short checklist for choosing the right course


Use this checklist before booking confined space training.


  • Has a task-specific confined space risk assessment been completed?

  • Does the method of work involve low, medium or high-risk entry conditions?

  • Is there a realistic chance of low oxygen, toxic gas, fumes, vapour or flammable atmosphere?

  • Will entrants need escape breathing apparatus or working breathing apparatus?

  • Is access simple, or does it involve ladders, vertical entry, crawling or restricted openings?

  • Will a top person be required at the entry point?

  • Does the work need a supervisor with confined space knowledge?

  • Are rescue arrangements planned, equipped and trained?

  • Will the training include practical use of relevant equipment?

  • Are workers medically fit, experienced and supervised for the task they will carry out?


If the answers are unclear, do not guess the course level. Review the risk assessment and method of work first.


INFRATEC Training in Middlesbrough provides practical confined space training for organisations selecting low, medium or high-risk routes. Training can also be delivered on site for groups across the UK, which is useful when teams need training linked to their own equipment, work environment and procedures. Online booking is available for those ready to choose a course.


FAQ


Is low-risk confined space training enough for chamber work?


Not always. Some chamber work may be low risk, but deeper chambers, poor ventilation, difficult access, gas risk or the need for rescue equipment can raise the level. The risk assessment and work method decide the training need.


When do I need medium-risk confined space training?


Medium-risk training is usually suitable where entry involves more than basic access and awareness. It may include controlled entry, gas monitoring, a top person, harnesses, tripods and escape breathing apparatus.


When is high-risk confined space training needed?


High-risk training is usually needed where the entry is complex, the atmosphere may be hazardous or working breathing apparatus is required. It may also apply where rescue would be difficult or specialist team roles are needed.


What is the difference between escape BA and working BA?


Escape BA is for leaving a space in an emergency. Working BA is used to carry out the task while breathing from the set. They involve different risks, procedures and training needs.


Does completing a course make someone competent?


No. Training is one part of competence. Employers also need to consider experience, supervision, fitness, equipment familiarity, site procedures and the specific task.


Choose training that matches the real job


The safest starting point is not a course brochure. It is the task-specific risk assessment, the method of work and the rescue plan.


Once those are clear, the training choice becomes much easier. Low-risk training may suit straightforward entries with simple controls. Medium-risk training may be needed where access, atmosphere and emergency arrangements require more control. High-risk training is for complex entries, especially where working breathing apparatus or specialist rescue arrangements are involved.


To take the next step, view INFRATEC’s confined-space courses and book online, or telephone 01642 654963 to discuss practical training at INFRATEC Training in Middlesbrough or UK-wide on-site group delivery.


 
 
 

Comments


bottom of page